Battletech Miniatures - Mad Cat Mk IV - SirMortimerBombito Sculpt
$12.94
"Timber 4" sculpt (Multi-part) by SirMortimerBombito
The miniatures are 3D-Printed using Grey model resin:
- The minis are unprimed and unpainted.
- Like any 3D print they may be subject to minor imperfections (small support structures). You may have to do some light filing and sanding before priming.
- All the supports have been placed manually (no auto support !!!) to maximise the quality of the prints.
Allow for a week or so for your order to be processed and shipped.
Any question or special requests, just message me.
***************************************
Please keep in mind that I pack these miniatures as meticulously as I can and securely as possible. If there is an issue where an arm or a leg snap off it is usually easy enough to sand/glue it back on without an issue. Normally I will not send out a replacement unless that mech is completely demolished making it unfix-able. If that is the case, please send a pic and I will get a replacement out as soon as possible.
I will accept all returns, no questions asked, the buyer pays for tracked return postage.
***************************************
Reviews (4)
Average:
Dec 4, 2022
August Rich
Dec 1, 2022
Loving the Savage Wolves as i haven't been able to get them anywhere else!
mooverna
Nov 25, 2022
Well printed model that required minimal clean up. It's a tad too large compared to the CGL models. If the current model was printed at 85-90%, it would be closer to 1/265 scale.
seanbrooksirwin
Sep 19, 2022
Very good miniature, and very fast international shipping
Timothy Croyle