Generic Markers Waterslide Decals for Battletech

$7.91

Shipping to United States: $9.61


Waterslide decals to use with Battletech:

Numbers & Markers
************************
- 72x Black Numbers 01-12
- 72x Green Numbers 01-12
- 72x Yellow Numbers 01-12
- 72x Red Numbers 01-12
- 48x Warning Triangles
- 44x Mech Kill Markers

Stripes & Checkers
*********************
- 20x 5x5mm Black and Yellow Stripes
- 6x 5x15mm Black and Yellow Stripes
- 8x 5x10mm Black and Yellow Stripes
- 4x 20x20mm Black and Yellow Checkers
- 4x 20x20mm Black and Red Checkers
- 4x 20x20mm Black and Blue Checkers
- 10x Radiation Hazard
- 12x Danger Warning
- 12x High Energy Laser Warning


Card Suites
*************
- 16x 10mm roundels (4 of each Clubs, Hearts, Diamonds and Spades)
- 72x 5mm roundels (18 of each Clubs, Hearts, Diamonds and Spades)

Lady Luck Pinup
******************
- 12x 10mm roundels
- 24x 8mm roundels
- 24x 6mm roundels


*************************************************
How to get the best of our waterslide decals
*************************************************

The optimal preparation of the mini depends on the type of decals you have purchased from us:
- Standard decals on clear paper/substrate:
if applied on a dark surface or if you want to make sure it “pops”, first apply a coat of white paint where the decal is meant to go on the mini (we recommend using a white acrylic pen)

- Standard decals on white paper/substrate :
no need to apply a white undercoat on the mini as the decals are fully opaque. You need to cut them very precisely, however.

- Premium decals with white ink underlayer:
they can be applied to any paint scheme, even dark ones, without a white undercoat on the mini. They can also be cut loosely around the shape as the substrate is clear.

- Cut it from the sheet
- Soak it in water until you can slide it from the backing paper with your finger but not so much as it detaches by itself from the paper; if you leave it in water for too long the starch substrate dissolves too much and the decal loses its integrity
- Transfer the decal from your finger onto the mini
- Use a cotton bud (or QTip) to adjust the decal precisely in position and remove the excess water
- Once the water is mostly evaporated but the decal is still moist, dab it carefully (and orthogonally) with a QTip soaked in Microsol solution to "melt" the decal in place
- Let it dry
- Optionally (if you have applied a white undercoat), touch up the paint job around the decal
- Finally, spray a clear coat of varnish

The decals are well detailed, and of good quality. Shipping is terribly slow, but that's not the fault of the Vendor.


Great stuff. Well made and looks great.


Exactly what I was expecting


Great quality. Exceeds expectations. Will purchase from seller again.


Product was great shipping was an issue though


Legal imprint